Recent content by washnshine

That’s your call - I just think for the sake of throughput and cph, I would want off board drying no matter what I bought.

Why would you need onboard dryers with the 360? Don’t they have an option to use drive through? That alone would be a big factor in my decision, not to mention many other considerations.

Did not know that.

There is an exterior express chain in my region that is building a wash literally a few hundred yards away from another existing tunnel. The chain approached the owner of the existing wash and asked if he would sell - he said no and they broke ground next to him.

I think it’s funny how the whole thread was initiated to get these machines in ASAP and as fast as possible and we are discussing it four years later, not knowing if anyone ever installed them.

I do not have dryers in my bays, but I’m also guessing that with a greater increase in hose length (like you would get with a roof mount), you loose some velocity coming out of the nozzle.

I know a lot of operators have a dryer timer (not that it always helps) but has anyone seen an undercarriage timer for driving in? I see more people run out of undercarriage time than dryer time.

And the big X - Factor. Will there be an express exterior or two close enough (and that might not even mean the same town as you) to take a major bite out of your wash. I know EE’s generally don’t build in a population of 3000, but they do build in areas that have a cumulative larger...

Driver side - counter clockwise if you looked down at it from the top. Passenger side clockwise if you looked down at it from the top. They should spin in the direction of vehicle travel - like they are rolling the vehicle through the brushes.

I know nothing about MCWW equipment. Do they offer a flexible shaft coupling for their wraps? I don’t think I would get a set of wraps without a flexible coupling.

Watch the bay width. I’ve seen installations of various machines where the side brushes make contact with the walls when they are spinning. I would never want this - it will just give you early brush wear and tear. It’s also not going to be as effective on the car because it will be knocking...

Oh I know you were! Ceramics are great - it’s like the customers that use those quick detail sprays on their cars or keep them regularly waxed- it helps us out.

And the upside to ceramic: Bugs and bird droppings do not stick to the car as they did without ceramic!

What’s the scent of the Silk. Do customers like it?

Good advice from the above posts. One other thought: High pressure and high foam sealant products usually do not go together. Most products that provide a more significant foam are low pressure - or applied low pressure